Connecting the Live-View Remote(RM-LVR2V) to Multiple Cameras
- Multi Connection -

You can connect a maximum of five cameras to the remote control and operate all cameras simultaneously.

STEP1. Checking the Connection Mode of the Live-View Remote

Turn on the power of the remote control
Press the MENU button to select (Connection mode) in (Remote control setting), then select (Multi connection)

STEP2. Connect the remote control and a camera through Wi-Fi.

Press the MENU button to select (Device registration)
- The device registration screen will be displayed on the LCD screen of the remote control, and the camera and remote control enter the waiting state for the multi connection.
Turn on the power of the camera
Press the Wi-Fi button of the camera to switch to the multi connection
Press and hold the Wi-Fi button of the camera
- When a connection request is sent from the camera to the remote control, a beep sounds.
Press the OK button displayed on the LCD screen of the remote control.
- After the connection is established, the LCD screen of the remote control switches to the Live-View display.
Repeat the procedure from < STEP2 > to connect to an additional camera

Note

Register each camera before the connection standby mode of the camera is cancelled.
The multi camera control function is only available with compatible cameras.
When operating a camera that does not support the multi camera control function, set the remote control to (Single connection).
You cannot copy images recorded in the camera to the remote control.
The WPS method is used to connect the remote control to multiple cameras. If there is another device using the WPS method in the vicinity of the cameras, the registration may fail. If the registration fails, reconnect by performing each step again.