SONY

NEX-6 - SEL600F40GM |Compatibility Information

SEL600F40GM

SEL600F40GM

FE 600mm F4 GM OSS

sample: SEL600F40GM

When using a lens directly mounted on the camera:

  • The camera system software Ver.1.02 or later, the Exif [focal length] is recorded.
  • Optical SteadyShot setting on lens will switch on/off the function, but the setting is not reflected to on-screen display (LCD monitor / viewfinder) nor recorded in EXIF data.
  • Focus hold button of the lens does not work.
  • Fast Hybrid AF is available in the center area with the system software Ver.1.03 or later.
  • Even if the focus-range setting switch is set to near zone, the shooting focus range will be the same as Full
  • When the autofocus mode is set to something other than AF-C and the amount of focus movement is large until the focus is achieved, sometimes the exposure is incorrect after focus is achieved. The correct exposure can be obtained by pressing the shutter button halfway again or using AEL again.
  • Exif lens names will not be recorded correctly.
  • The camera may be out of focus when set to Continuous AF.

When using a teleconverter lens:

SEL14TC

  • The camera may be out of focus when set to Continuous AF.
  • The focal length and maximum aperture for the Exif lens name will be listed using magnification values. However, when the aperture values multiplied by magnification are 10 or higher, they will not display correctly.

SEL20TC

  • The camera may be out of focus when set to Continuous AF.
  • The focal length and maximum aperture for the Exif lens name will be listed using magnification values. However, when the aperture values multiplied by magnification are 10 or higher, they will not display correctly.
  • Focal plane phase detection AF cannot be used, so Contrast AF will operate.