Functions of this App

1. : Set the Wi-Fi connection mode to single connection.
2. : Launch Imaging Edge Mobile on your smartphone and proceed as follows.

   When Imaging Edge Mobile has been newly installed

   [Models other than the above] → [Camera Connection/Registration]

   When adding a second (or subsequent) camera to a previously installed instance of Imaging Edge Mobile

   [Camera Connection/Registration] → [Register other models]

3. : Select [Connect using the camera SSID/password] → [Enter SSID/Password], then enter the SSID (DIRECT-xxxx: xxxx) and password displayed on the camera.

Refer to <Operating the camera remotely> for operation instructions.

This connection method is only available for NFC-compatible Android devices and for the iPhone 7 and later models.

1. : Set the Wi-Fi connection mode to single connection.
2. : Launch Imaging Edge Mobile on your smartphone and proceed as follows.

   When Imaging Edge Mobile has been newly installed

   [Models other than the above] → [Camera Connection/Registration]

   When adding a second (or subsequent) camera to a previously installed instance of Imaging Edge Mobile

   [Camera Connection/Registration] → [Register other models]

3. : Select [Connect with the camera through One-touch (NFC)] → [Tap here].
4. : Switch the camera to the shooting mode and display the [N] mark on the monitor. Then, touch the smartphone to the camera.

Refer to <Operating the camera remotely> for operation instructions.

If the camera and the smartphone are already connected via Wi-Fi before you launch Imaging Edge Mobile, the camera name will be displayed in the [Camera List]. Tap [Start] to the right of the camera name.