![]() |
|
Click on one of the files below (NEX-3V3_Update1010a.exe or NEX-5V3_Update1010a.exe) to begin download. Please save the downloaded file onto the Desktop of your computer (recommended). |
||||||
|
||||||
![]() ![]() |
||||||
![]() ![]() |
||||||
![]() |
Double-click [NEX-5V3_Update1010a.exe]* to start up Firmware Updater (Figure 2). * For NEX-3, the file name is [NEX-3V3_Update1010a.exe]. ![]() (Figure 2) |
![]() |
According to the instruction on Firmware Updater, select [Menu] - [Setup] - [USB Connection] on the camera, and check if [Mass Storage] is selected (Figure 3). If the mode other than [Mass Storage] is selected, please select [Mass Storage]. ![]() (Figure 3) |
![]() |
|
|
|
Click [Run] to start the upgrade. The progress bar appears while upgrading (approximately 3 minutes). ![]() (Figure 11)
|
||||||||||||
![]() |
When the upgrade is completed, the screen on Figure 12 appears. Click [Finish] and disconnect the USB cable. ![]() (Figure 12)
|
||||||||||||
![]() |
Follow the instruction below to confirm the firmware version is Ver.03. Select [Menu] - [Setup] - [Version] on the camera. The firmware version is displayed (Figure 13). ![]() (Figure 13) |
![]() |
![]() |
![]() |
![]() |
![]() |