Functions of this App
FDR-X3000 : Remote shooting
- Connecting by QR Code
-
: Select MENU → → → .
-
: Select the shooting mode ( ⁄ ⁄ ⁄ ).
-
: Launch Imaging Edge Mobile on your smartphone and proceed as follows.
When Imaging Edge Mobile has been newly installed
[Models other than the above] → [Camera Connection/Registration]
When adding a second (or subsequent) camera to a previously installed instance of Imaging Edge Mobile
[Camera Connection/Registration] → [Register other models]
-
: Select [Scan QR Code], then scan the QR Code displayed on the camera with your smartphone.
Refer to <Operating the camera remotely> for operation instructions.
-
- Connecting by Wi-Fi Using an SSID and Password
-
: Select MENU → → → .
-
: Select the shooting mode ( ⁄ ⁄ ⁄ ).
-
: Launch Imaging Edge Mobile on your smartphone and proceed as follows.
When Imaging Edge Mobile has been newly installed
[Models other than the above] → [Camera Connection/Registration]
When adding a second (or subsequent) camera to a previously installed instance of Imaging Edge Mobile
[Camera Connection/Registration] → [Register other models]
-
: Select [Connect using the camera SSID/password] → [Enter SSID/Password], then enter the SSID (DIRECT-xxxx: xxxx) and password displayed on the camera.
Refer to <Operating the camera remotely> for operation instructions.
-
- Connecting by Wi-Fi Using NFC
This connection method is only available for NFC-compatible Android devices and for the iPhone 7 and later models.
-
: Select MENU → → → .
-
: Select the shooting mode ( ⁄ ⁄ ⁄ ).
-
: Launch Imaging Edge Mobile on your smartphone and proceed as follows.
When Imaging Edge Mobile has been newly installed
[Models other than the above] → [Camera Connection/Registration]
When adding a second (or subsequent) camera to a previously installed instance of Imaging Edge Mobile
[Camera Connection/Registration] → [Register other models]
-
: Select [Connect with the camera through One-touch (NFC)] → [Tap here].
-
: Switch the camera to the shooting mode and display the [N] mark on the monitor. Then, touch the smartphone to the camera.
Refer to <Operating the camera remotely> for operation instructions.
-
- Bluetooth
The camera can be powered on and off from a smartphone by connecting the camera and the smartphone via Bluetooth.
-
: Select MENU → → → .
-
: Select MENU → → → .
-
Connect the camera and the smartphone using Wi-Fi (first time only).
-
: Select [Camera Remote Power ON/OFF] from the Imaging Edge Mobile menu.
-
: When a message prompting you to allow the pairing appears on the screen, allow it (first time only).
-
: Press the REC/ENTER button on the camera to complete the pairing (first time only).
-
- Multi Camera Control
You can connect up to 5 cameras simultaneously to perform shooting.
You must use a smartphone equipped with a tethering function.
Multi Camera Control - If the camera and the smartphone are already connected
If the camera and the smartphone are already connected via Wi-Fi before you launch Imaging Edge Mobile, the camera name will be displayed in the [Camera List]. Tap [Start] to the right of the camera name.