SONY

SEL50F14GM - ILCE-7 ｜Compatibility Information

ILCE-7

ILCE-7

  • The SteadyShot is not supported.
  • Fast Hybrid AF is available with the system software Ver.1.02 or later.
  • When Iris ring is switched between auto iris mode and manual iris mode, on-screen display (LCD monitor /Viewfinder) may flicker for a brief second and focus position may be reset. These will be fixed with the camera system software Ver.1.02 or later.
  • When the Iris ring is set to manual iris mode, the Lens Model and Max Aperture Value of the Exif are not recorded correctly. It will be fixed with the camera system software Ver.1.02 or later.
  • When the Exposure step of the camera is set to on 0.5 stop basis while the Iris ring of the lens steps on 0.3 stop basis, the on-screen (LCD monitor /Viewfinder) display and Exif are recorded on 0.5 stop basis, and these may be different from actual aperture value.
  • When the Iris ring is set to manual iris mode, the aperture value is set at the value which Iris ring indicates regardless of exposure mode. With the camera system software Ver.1.02 or later, the aperture value is set automatically except for A and M exposure mode as usual.
  • When Iris ring is switched between auto iris mode and manual iris mode during movie recording, the recording will be stopped. It will be fixed with the camera system software Ver.1.02 or later.
  • If you rotate the Iris ring, the time before Power Save is not extended. It will be fixed with the camera system software Ver.1.02 or later.
  • Aperture value is not registered correctly when you register settings by means of Memory function.
  • You can use the focus hold button with software Ver. 1.02 or later installed on the camera.
  • When the autofocus mode is set to something other than AF-C and the amount of focus movement is large until the focus is achieved, sometimes the exposure is incorrect after focus is achieved. You can use this with system software Version 1.20 or higher installed in the camera.
  • Exif lens names will not be recorded correctly. Update the system software of the camera to Ver. 3.10 or later to ensure correct display.