ILCE-7RM3A - HVL-F60RM ｜Compatibility Information
HVL-F60RM
| Attaching |  |
|---|---|
| ADI flash metering | — |
| Burst | *49 |
| P-TTL flash metering | |
| Auto Zoom | |
| Flash Range Display | |
| HSS (High-Speed Sync) | |
| Optical controlled wireless remote HSS | *10 |
| Optical controlled wireless remote flash | *10 |
| Optical controlled wireless controller | *7 |
| Optical controlled wireless Ratio (Controller) | *7 |
| Optical controlled wireless Ratio (Remote) | *8 |
| Radio controlled wireless HSS | *29 |
| Radio controlled wireless receiver flash | *29 |
| Radio controlled wireless commander | *30 |
| Radio controlled wireless Ratio (commander) | *30 |
| Radio controlled wireless Ratio (receiver) | *29 |
| Slow sync | |
| Modeling | |
| Multiple flash | |
| Manual flash | |
| AF illuminator | |
| Auto zoom control optimized for image sensor size | |
| Auto WB Adjustment with Color Temperature Info | |
| Red-Eye Reduction | |
| Flash Compensation | |
| FEL Lock | |
| Remote release | *34,36,49 |
| External Flash Settings | *46,47,48 |
| Register Flash Shooting Settings | — |
*7 A separate wireless remote flash is required.
*8 A separate wireless controller (either an HVL-F43AM, HVL-F58AM, HVL-F60M or HVL-F43M) is required.
*10 A separate wireless controller (either an HVL-F20AM, HVL-F43AM, HVL-F58AM, HVL-F60M, HVL-F20M, HVL-F43M, or HVL-F32M) is required.
*29 Requires Radio Control Wireless Flash(sold separately) or Wireless Radio Commander FA-WRC1M(sold separately).
*30 Requires Radio Control Wireless Flash(sold separately) or Wireless Radio Receiver FA-WRR1(sold separately).
*34 Requires a remote release radio control wireless flash (sold separately), or the Wireless Radio Commander FA-WRC1M (sold separately), or the Wireless Radio Receiver FA-WRR1 (sold separately).
*36 Requires the Multi Terminal Connecting Cable VMC-MM1 (sold separately).
*46 It is supported by updating the camera system software version "Ver.3.10" or later.
*47 You can only use [External Flash Set.] when the flash is attached directly to the camera. You cannot use this function when shooting with an off-camera flash that is connected using a cable.
*48 It is supported by updating the flash system software version "Ver.2.00" or later.
*49 Cannot be used when the electronic shutter is enabled. (On cameras that support Pixel Shift Multi Shooting, operates when the electronic shutter is enabled only during Pixel Shift Multi Shooting)