ILCE-5000 - SEL70200G2 ｜Compatibility Information

SEL70200G2

FE 70-200mm F4 Macro G OSS Ⅱ

When using a lens directly mounted on the camera：

The [Lens Comp.: Distortion] setting will be set to "Auto".
Optical SteadyShot setting on lens will switch on/off the function, but the setting is not reflected to on-screen display (LCD monitor / viewfinder) nor recorded in EXIF data.
Focus hold button of the lens does not work.
When the Focus Mode switch is set to MF, it is not possible to tentatively resume AF mode by pressing the custom key which is assigned to AF/MF control on, though the on-screen (LCD monitor /Viewfinder) focus mode switches to AF.
Even if the focus-range setting switch is set to near zone, the shooting focus range will be the same as Full
When the autofocus mode is set to something other than AF-C and the amount of focus movement is large until the focus is achieved, sometimes the exposure is incorrect after focus is achieved. The correct exposure can be obtained by pressing the shutter button halfway again or using AEL again.

When using a teleconverter lens：

The [Lens Comp.: Distortion] setting will be set to "Auto".
When the autofocus mode is set to something other than AF-C and the amount of focus movement is large until the focus is achieved, sometimes the exposure is incorrect after focus is achieved. The correct exposure can be obtained by pressing the shutter button halfway again or using AEL again.
The focal length and maximum aperture for the Exif lens name will be listed using magnification values. However, when the aperture values multiplied by magnification are 10 or higher, they will not display correctly.

The [Lens Comp.: Distortion] setting will be set to "Auto".
When the autofocus mode is set to something other than AF-C and the amount of focus movement is large until the focus is achieved, sometimes the exposure is incorrect after focus is achieved. The correct exposure can be obtained by pressing the shutter button halfway again or using AEL again.
The focal length and maximum aperture for the Exif lens name will be listed using magnification values. However, when the aperture values multiplied by magnification are 10 or higher, they will not display correctly.