SONY

ILCE-6000 - SEL50F12GM ｜Compatibility Information

SEL50F12GM

FE 50mm F1.2 GM
sample: SEL50F12GM
  • The SteadyShot is not supported.
  • When Iris ring is switched between auto iris mode and manual iris mode, on-screen display (LCD monitor /Viewfinder) may flicker for a brief second and focus position may be reset.
  • When the Iris ring is set to manual iris mode, the Lens Model and Max Aperture Value of the Exif are not recorded correctly.
  • When the Exposure step of the camera is set to on 0.5 stop basis while the Iris ring of the lens steps on 0.3 stop basis, the on-screen (LCD monitor /Viewfinder) display and Exif are recorded on 0.5 stop basis, and these may be different from actual aperture value.
  • When the Iris ring is set to manual iris mode, the aperture value is set at the value which Iris ring indicates regardless of exposure mode.
  • When Iris ring is switched between auto iris mode and manual iris mode during movie recording, the recording will be stopped.
  • If you rotate the Iris ring, the time before Power Save is not extended.
  • When the Iris ring is set to manual mode, Background Defocus Control in Photo Creativity does not work correctly however the on-screen display is shown as is conventionally done.
  • When the Iris ring is set to manual iris mode, aperture value is not registered correctly when you register settings by means of Memory function.
  • Exif lens names will not be recorded correctly. Update the system software of the camera to Ver. 3.10 or later to ensure correct display.
  • When F1.2 is selected in manual iris mode, the value displayed on the camera and the Exif value recorded is F1.3, but the actual aperture value used for shooting is F1.2.
  • When F1.7 is selected in auto iris mode, the Exif value recorded is F1.7, but the actual aperture value used for shooting is F1.8.
  • When F1.8 is selected in manual iris mode, the value displayed on the camera is F1.7, but the actual aperture value used for shooting is F1.8.
  • When the exposure step of the camera is set to 0.3 stop basis, it is not possible to register an aperture value of F1.2 as a custom hold setting. You can register an aperture value of F1.2 when the exposure step is set to 0.5 stop basis.
  • When the exposure step is set to 0.3 stop basis, it is not possible to set an aperture value of F1.2 or F1.3 from Imaging Edge Mobile or Imaging Edge Desktop (Remote).