NEX-C3 - SEL300F28GM |Compatibility Information
SEL300F28GM
FE 300mm F2.8 GM OSS
When using a lens directly mounted on the camera:
- Sliding the Focus Mode switch to MF position will change the focus mode setting, but on-screen (LCD monitor /Viewfinder) focus mode display will not change.
- Optical SteadyShot setting on lens will switch on/off the function, but the setting is not reflected to on-screen display (LCD monitor / viewfinder) nor recorded in EXIF data.
- Focus hold button of the lens does not work.
- When the Focus Mode switch is set to MF while AF is selected at body side, focus mode is manual but MF Assist will not work. (AF will not work as well.)
- When the autofocus mode is set to something other than AF-C and the amount of focus movement is large until the focus is achieved, sometimes the exposure is incorrect after focus is achieved. The correct exposure can be obtained by pressing the shutter button halfway again or using AEL again.
- Exif lens names will not be recorded correctly.
When using a teleconverter lens:
SEL14TC
- The camera may be out of focus when set to Continuous AF.
- The focal length and maximum aperture for the Exif lens name will be listed using magnification values. However, when the aperture values multiplied by magnification are 10 or higher, they will not display correctly.
SEL20TC
- The camera may be out of focus when set to Continuous AF.
- The focal length and maximum aperture for the Exif lens name will be listed using magnification values. However, when the aperture values multiplied by magnification are 10 or higher, they will not display correctly.