Functions of this App
HDR-CX410VE : Remote shooting
* Wireless Adapter (ADP-WL1M) is required.
- Connecting by Wi-Fi Using an SSID and Password
-
: Select [Ctrl with Smartphone] from MENU →
(Network Settings), or MENU → [Wireless] → [
Function].
-
: Launch Imaging Edge Mobile on your smartphone and proceed as follows.
When Imaging Edge Mobile has been newly installed
[Models other than the above] → [Camera Connection/Registration]
When adding a second (or subsequent) camera to a previously installed instance of Imaging Edge Mobile
[Camera Connection/Registration] → [Register other models]
-
: Select [Connect using the camera SSID/password] → [Enter SSID/Password], then enter the SSID (DIRECT-xxxx: xxxx) and password displayed on the camera.
Refer to <Operating the camera remotely> for operation instructions.
-
- Connecting by Wi-Fi Using NFC
This connection method is only available for NFC-compatible Android devices and for the iPhone 7 and later models.
-
: Launch Imaging Edge Mobile on your smartphone and proceed as follows.
When Imaging Edge Mobile has been newly installed
[Models other than the above] → [Camera Connection/Registration]
When adding a second (or subsequent) camera to a previously installed instance of Imaging Edge Mobile
[Camera Connection/Registration] → [Register other models]
-
: Select [Connect with the camera through One-touch (NFC)] → [Tap here].
-
: Switch the camera to the shooting mode and display the [N] mark on the monitor. Then, touch the smartphone to the camera.
Refer to <Operating the camera remotely> for operation instructions.
-
- If the camera and the smartphone are already connected
If the camera and the smartphone are already connected via Wi-Fi before you launch Imaging Edge Mobile, the camera name will be displayed in the [Camera List]. Tap [Start] to the right of the camera name.