DSC-WX220 : Remote shooting

  • Connecting by QR Code

    Terms on the screen may be different depending on your camera and smartphone.

    1. : On models that have the camera application [Smart Remote Control], select MENU →  (Application) → [Application List] and launch [Smart Remote Embedded] or [Smart Remote Control].
      On models that do not have [Smart Remote Control], select [Ctrl w/ Smartphone] from the menu of the camera.
    2. : Launch Imaging Edge Mobile on your smartphone.
    3. :

      When connecting with a new camera

      Select [Connect with a new camera] → [Scan QR Code], then scan the QR Code displayed on the camera with your smartphone.

      With a camera that has been connected previously

      Select the camera name, which will be displayed in the [Camera List].

  • Connecting by Wi-Fi Using an SSID and Password

    Terms on the screen may be different depending on your camera and smartphone.

    1. : On models that have the camera application [Smart Remote Control], select MENU →  (Application) → [Application List] and launch [Smart Remote Embedded] or [Smart Remote Control].
      On models that do not have [Smart Remote Control], select [Ctrl w/ Smartphone] from the menu of the camera.
    2. : Launch Imaging Edge Mobile on your smartphone.
    3. :

      When connecting with a new camera

      Select [Connect with a new camera] → [Connect using the camera SSID/password] → [Enter SSID/Password], then enter the SSID (DIRECT-xxxx: xxxx) and password displayed on the camera.

      With a camera that has been connected previously

      Select the camera name, which will be displayed in the [Camera List].

  • Connecting by Wi-Fi Using NFC
    1. : Launch Imaging Edge Mobile on your smartphone.
    2. :

      When connecting with a new camera

      Select [Connect with a new camera] → [Connect with the camera through One-touch (NFC)] → [Tap here].

      With a camera that has been connected previously

      Select the camera name, which will be displayed in the [Camera List].

    3. : (Only when connecting with a new camera) Switch the camera to the shooting mode and display the [N] mark on the monitor. Then, touch the smartphone to the camera.

    For iPhone/iPad
    This connection method is only available for the iPhone 7 and later models.

  • If the camera and the smartphone are already connected

    If the camera and the smartphone are already connected via Wi-Fi before you launch Imaging Edge Mobile, perform the following procedure.

    If the camera name is displayed in the [Camera List]

    Select the camera name or [Start].

    If the camera name is not displayed in the [Camera List]

    Select [Connect with a new camera] → [Wi Fi connected to camera].

Return to Top