FDR-X1000V : Remote shooting

  • Connecting by Wi-Fi Using an SSID and Password
    1. On the camera : Select [SETUP] → [CONFG] → [Wi-Fi] → [ON].
    2. On the camera : Select the shooting mode (LOOP/MOVIE/PHOTO/INTVL).
    3. On the smartphone : Launch Imaging Edge Mobile on the smartphone.
    4. On the smartphone :

      When connecting with a new camera

      Select [Connect with a new camera] → [Connect using the camera SSID/password] → [Enter SSID/Password], then enter the SSID (DIRECT-xxxx: xxxx) and password attached to the Startup Guide.

      With a camera that has been connected previously

      The camera name appears in [Camera List]. Tap [Start] next to it.

    Refer to <Operating the camera remotely> for operation instructions.

  • Connecting by Wi-Fi Using NFC

    This connection method is only available for NFC-compatible Android devices and for the iPhone 7 and later models.

    1. On the camera : Select [SETUP] → [CONFG] → [Wi-Fi] → [ON].
    2. On the camera : Select the shooting mode (LOOP/MOVIE/PHOTO/INTVL).
    3. On the smartphone : Launch Imaging Edge Mobile on your smartphone.
    4. On the smartphone :

      When connecting with a new camera

      Select [Connect with a new camera] → [Connect with the camera through One-touch (NFC)] → [Tap here].

      With a camera that has been connected previously

      The camera name appears in [Camera List]. Tap [Start] next to it.

    5. On the camera : (Only when connecting with a new camera) Switch the camera to the shooting mode and display the [N] mark on the monitor. Then, touch the smartphone to the camera.

    Refer to <Operating the camera remotely> for operation instructions.

  • Multi Camera Control

    You can connect up to 5 cameras simultaneously to perform shooting.
    You must use a smartphone equipped with a tethering function.
    Multi Camera Control

  • If the camera and the smartphone are already connected

    If the camera and the smartphone are already connected via Wi-Fi before you launch Imaging Edge Mobile, perform the following procedure.

    If the camera name is displayed in the [Camera List]

    Tap [Start] next to the camera name.

    If the camera name is not displayed in the [Camera List]

    Select [Connect with a new camera] → [Wi Fi connected to camera].

Was this article helpful?
We are holding a simple survey to further improve our services. If you could answer the survey, it would be much appreciated.
Your responses will be used to further develop and improve our products/services. The survey responses will be processed statistically and will not be disclosed in a manner in which an individual can be distinguished.

Why has this not helped?






Return to Top