SONY

1-1. Preparing Action Cam

When using HDR-AZ1

Step 1
Insert a memory card into the Action Cam.
 
Diagram 1: With microSD / microSDHC / microSDXC cards, the printed side is displayed with A.
 
Diagram 2: With Memory Stick Micro™ (Mark2), the terminal side is displayed with B.
Step 2
Press the ON/OFF button to turn on the camcorder.
Step 3
Confirm that [Wi-Fi] is diaplayed on the camcorder. Press the Wi-Fi button to switch the mode. Select Single connection to operate the camcorder from the smartphone.
 
1. Single connection
 
2. Multi connection
 
3. Live connection
 
4. Wi-Fi off
PAGE TOP

When using FDR-X1000V or HDR-AS15/ AS20/ AS30V/ AS100V/ AS200V

Step 1
Insert a memory card into the Action Cam.
  • Smart Remote Control cannot be used unless a memory card is inserted in the Action Cam.
Step 2
Press the [NEXT] button to turn on the camcorder.
Step 3
Press the [NEXT] button several times until [SETUP] appears, then press the [ENTER] button.
Step 4
Use the [NEXT] and [ENTER] buttons to select [CONFG], then [Wi-Fi]. (For HDR-AS15/20/30V, use the [NEXT] and [ENTER] buttons to select [Wi-Fi] or [RMOTE].)
Step 5
Press the [NEXT] button to display [ON], then press the [ENTER] button.
Step 6
Press the [NEXT] button to display [LOOP] (loop recording mode), [MOVIE] (movie mode), [PHOTO] (photo mode), or [INTVL] (interval photo recording mode).
  • The selectable recording modes vary depending on the product.
Step 7
Check the [Wi-Fi] icon is displayed at the upper left corner of the display panel.
PAGE TOP