Check the firmware version by following the instructions below.
If the firmware version is "Ver.1.10", the update has been performed correctly.

1. Turn ON the camera power.
2. Press the MENU button to display the menu.
3. Select Tab 3 of the Setup Menu() using the horizontal buttons() of the control button.
   
   
4. Select "Version" by pressing the down button() of the control button.
   
   
   
5. Press the center of the control button
6. The firmware version will be displayed on the LCD monitor.
   Confirm that the version is "Ver.1.10"
   
   
   
   Press the center of the control button to close the version display.

		If updating procedure was not finished rightly or cannot turn on the camera, please consult local authorized Sony service facility. After updating the camera, format the recording medium or delete the update file from the recording medium.