Setting up the camera

Opening the cover and inserting the battery

Open the battery/memory card cover.

Insert the battery pack while pressing the lock lever (A) with the tip of the battery until the battery locks into place.

Inserting the memory card

With the notched corner facing in the direction illustrated, insert the memory card until it clicks into place. Insert the memory card correctly. Not doing so may cause a malfunction.

Close the cover, and then slide the switch to the locked position.

Turning the power off

Turn off the camera before charging the battery.

Charging the battery pack

You can use a USB cable to charge from an external power source, such as a commercially available USB AC adaptor or mobile battery.
Charging time (Full charge): The charging time is approximately 150 min. (when using an AC adaptor with a rated output of 1.5 A).
The above charging time applies when charging a fully depleted battery pack at a temperature of 25 °C (77 °F). Charging may take longer depending on conditions of use and circumstances.
The charge lamp turns off when charging is completed.
If the charge lamp lights up and then immediately turns off, the battery pack is fully charged.

Charge lamp on the camera (orange)
Lit: Charging.
Off: Charging finished.
Flashing: Charging error or charging paused temporarily because the camera is not within the proper temperature range.